Figure 26
Left front cutting unit (#4)
1. Extra flange nut
2. Connector plate
6.
Repeat the procedure on the remaining 4
bulkhead locations as shown in
through
Figure
30.
Important:
The connector plates are
positioned differently at the remaining
locations so the hose can be routed through
the bulkhead bracket and to the cutting unit
without getting twisted or kinked.
Figure 27
Left rear cutting unit (#2)
1. Bulkhead bracket
2. Extra flange nut
g316962
3. Bulkhead bracket
Figure 27
g316994
3. Connector plate
Center front cutting unit (#1)
(Underside of machine shown)
1. Connector plate
2. Extra flange nut
Right front cutting unit location (#5)
1. Bulkhead bracket
2. Connector plate
19
Figure 28
3. Bulkhead bracket
Figure 29
3. Extra flange nut
g316976
g316996