Table of Contents
Advertisement
Lamp replacement
A lamp is consumable supplies. If used for extended periods, images will appear dark, and
the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime
of the lamp depends on condition of use.) If this happens, replace it with a new one.
WARNING
• If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealer-
ship when the lamp has to be exchanged.
Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger
of damage from falling pieces of glass if the lamp is broken. Besides, working at high
elevations can also be hazardous. Do not attempt to replace the lamp by yourself.
• When replacement is required, be sure to use TLPLW11 (sold separately).
CAUTION
• If you have been using the projector, the lamp will be very hot, and may cause burn
injuries. Wait for the lamp to cool (for longer than 1 hour) before replacing it.
• If the lamp should break, please handle with care to avoid injury due to broken pieces
(
) and contact your dealer for repair service.
p.43
1
Unplug power cord.
2
Wait until lamp is sufficiently cooled.
Wait for at least 1 hour.
Remove the lamp cover.
3
Loosen the two screws, raise the lamp cover
with your fingers as shown to remove the lamp
cover. Use care to avoid any damage to nails
and/or tip of your finger(s). If you have any
difficulty in removal, you can use a screwdriver
or any other smaller tool for your convenience.
Pull out the lamp.
4
Loosen the three lamp locking screws, pull up the
handle, and remove the lamp.
All manuals and user guides at all-guides.com
3
Lamp cover
4
44
1
2
1
2
5
Mount the new lamp.
Align the orientation, press down
until the bottom is reached, and l
the three lamp locking screws.
6
Replace the lamp cove
Align the cover, and press it in, th
screws loosened in step
no longer loose.
7
Reset the lamp time.
See the lamp's manual for instruc
the lamp time.
Notes and Precautions
• The [Lamp time] item in the Status
rough guide)
p.42
• Please replace the lamp after 2000
setting 1 menu set to [Standard], a
Default setting 1 menu set to [Low
• There are cases that the lamp can
or before the replacement message
• Attach the lamp cover correctly so t
projector may fail to be powered on
• Always replace the lamp with a new
• The lamp is made out of glass. Do n
bang it, or scratch it. (Dirt, jolts, scra
About lamp replacement m
• The lamp replacement message
according to the use period for [S
• When the replacement time appro
Please change the lamp." and the
turned on. This display disappear
Used Lamps
This projector's lamps contain trac
mercury. Be careful not to break u
local regulations.
until t
3
Advertisement
Table of Contents
