Table of Contents
Advertisement
Home >
Appendix
>
the Single Active Docking Station on the Wall
Mount the Single Active Docking Station on the Wall
1. Drill four holes in a commercially available board according to the spacing of the screw holes of the Single
Active Docking Station.
b
a
a. Height: 1.18" (30 mm)
b. Width: 1.5" (38.1 mm)
2. Affix the Docking Station to the board using four screws, as shown in the illustration.
•
Make sure you install the Docking Station in the correct direction so that the printer will not fall.
•
Use M5 size screws.
3. Lean the board against the wall or secure the board to the wall.
Related Information
•
Single Active Docking Station (Optional: PA-CR-005)
Optional Accessories
>
Single Active Docking Station (Optional: PA-CR-005)
> Mount
206
Advertisement
Table of Contents
