Table of Contents
Advertisement
Home >
Appendix
>
the 4-bay Active Docking Station on the Wall
Mount the 4-bay Active Docking Station on the Wall
1. Drill four holes in a commercially available board according to the spacing of the screw holes of the 4-bay
Active Docking Station.
a
a. Height: 2.4" (61 mm)
b. Width: 16" (406.4 mm)
2. Affix the Docking Station to the board using four screws, as shown in the illustration.
•
Make sure you install the Docking Station in the correct direction so that the printer will not fall.
•
Use M5 size screws.
3. Lean the board against the wall or secure the board to the wall.
Related Information
•
4-bay Active Docking Station (Optional:PA-4CR-003)
Optional Accessories
b
>
4-bay Active Docking Station (Optional:PA-4CR-003)
> Mount
214
Advertisement
Table of Contents
