Using For The First Time; Starting The Inverter For The First Time; Fronius System Monitoring (Pilot) Display; Installation With The App - Fronius Tauro 50-3 Operating Instructions Manual

Using for the first time

Starting the in- When using the inverter for the first time, various setup settings must be con-
verter for the
figured.
first time
If the setup process is cancelled before the process is complete, any data that
has been input up to this point is lost and the start screen with the installation
wizard is shown again. If the process is interrupted, such as in the event of a
power outage, the data is saved. Commissioning may be continued from the point
at which the process was interrupted once the power supply has been restored. If
the setup was interrupted, the inverter feeds energy into the grid at maximum
500 W and the operating status LED flashes yellow.
The country setup can only be set when using the inverter for the first time. If
the country setup needs to be changed at a later date, please contact your in-
staller / Technical Support team.
Fronius system
monitoring (Pi-
lot) display
Installation with The "Fronius Solar.start" app is needed for this installation method. Depending
the app on the end device with which the installation will be carried out, download the
app for the respective platform.
1
2
3
4
5
Start the installation in the app.
Select the product to which the connection should be established.
Open the access point by touching the sensor once
flashes blue.
Follow and complete the installation wizard in the individual sections.
Add system components in Solar.web and start up the PV system.
To simplify the display, the vertical in-
stallation position of the Pilot pc board
(LED display) is shown horizontally be-
low.
→ Communication LED:
61