Guillotine - Horizon Fitness DSX 40 Operator's Manual

6.5.3 - Guillotine

As part of the metering assembly above the rotor chamber there is a stainless steel guillotine door.
It has 2 positions:
1. Work - Guillotine is in the outward position allowing product to flow to the metering housing
2. Maitenance position - Guillotine is in the Inward position stopping the flow of product to the
metering assembly to allow for easier maitenance work to be undertaken
IMPORTANT: The door must always be in one of the 2 positions listed above. If
removed completely during work there will be a loss of tank pressure, resulting in
poor metering performance
Working Position.
1. Pull pluger (1) to release the lock and slide the door rearward and remove the door from the
housing
2. Rotate 180° so the short edge engages with the opening
3. Lift Plunger (1) and slide the door into position until aligned with the locking plunger
Maitenance Position
1. Pull pluger (1) to release the lock and slide the door rearward and remove the door from the
housing
2. Rotate 180° so the long edge engages with the opening
3. Lift Plunger (1) and slide the door into position until aligned with the locking plunger. Once fully
engaged it is possible to remove the rollers with product still in the tank.
48 |