Ballasting Requirements; Data Required - Horizon Fitness DSX 40 Operator's Manual

3.4 - Ballasting Requirements

Before transportation on public roads the tractor must not be overloaded and meet the
requirements laid out in section 3.3 to be suitable for this implement. The load bearing capacity of
the tyres, maximum permissible weights and axle loads must not be exceeded when the implement
is hitched or mounted to the tractor. The front axle must be loaded with at least 20% of the curb
weight to maintain sufficient steering capabilities.
Due to the differing variants, equipment specifications and modular nature of the equipment the
implement should be weighed separately to determine its weight prior to the calculations below
being undertaken.

3.4.1 - Data Required

TL
TV
TH
GH Total weight of rear implement - For trailed machinery it is the
GV
a Distance between centre of gravity for front ballast to the centre
b
c
d Distance from the middle of the tractor lift arm balls to centre of
gravity for rear mounted implements. For Towed machinery d=0
22 |
Tractor curb weight
Front axle load of unladen tractor
Rear axle load of unladen tractor
maximum permissible drawbar load for road transport
of the front axle
Tractor wheelbase
Distance from the centre of the rear axle to the middle of the
tractor link arm ball
Front Weight
See tractor operating
manual
See section 3.1 or weigh
the implement.
See technical data for
front weight or weigh
See the technical data
for the tractor and front
weight or measure
See tractor operating
manual or measure
See Tractor operating
manual or measure