Hisense KFR 2101GWE Instruction Manual page 19

Anti-Mold Filter
How to remove the
anti-mold filter
Anti-Mold Filter
Cleaning
How to replace the
anti-mold filter
Air Clean Filter
(not provided)
!
WARNING
How to install the air clean
filter
Care and Cleaning (continued)
The anti-mode filter behind the air intake grille should be checked and cleaned
at least once every three weeks.
1.Grasp both ends of the air intake grille and pull it out and up.
2.Push the anti-mold filter up slightly, and then pull it down.
Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter,
wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.
1.With the "前面"(meaning FRONT) mark facing you, slide the anti-mold
filter up into the unit and then lower the handle into the groove on the unit.
2.After installing the anit-mold filter, press the locations marked by the arrows
( ) and close the air intake grille.
The air cleaning filter removes dust and dirt from the air, and reduces odors and
somke from tobacco.
This air clean filter cannot remove harmful gases or vapors nor ventilate
air in the room. You must open doors or windows frequently when you
use gas or oil heating appliances.Otherwise there is a risk of suffocation
in extreme cases.
The air clean filter needs to be installed behind the anti-mold filter.
1. Remove the anti-mold filter.
2. Install the air clean filter in the position shown in the diagram, with the"前面"
（meaning FRONT）symbol facing the front.
3. Reinstall the anti-mold fillter.
17
Air intake grille
Anti-mold filter
Air intake grille
Anti-mold filter
Air
clean
filter