You must strictly follow the instructions, to prevent accidents, personal injuries and property damages. DANGER! The signal word DANGER warns against hazards that lead to severe injuries or death if the hazards are not avoided. 2 / 26 700830...
Do not transport the appliance, holding it by the power cord. • Do not allow the power cord to come into contact with heat sources or sharp edges. • Do not bend, pinch nor knot the power cord. 700830 3 / 26...
Page 6
This appliance is not intended to be used by persons (including children) with limited physical, sensory or mental capabilities, nor by persons with limited experience and/or limited knowledge. • Children should be supervised to ensure that they are not playing with or switching the appliance on. Improper Use 4 / 26 700830...
Page 7
• Do not introduce any changes in the appliance nor modify it. • Do not drill hole in the appliance nor install any objects on it. • Do not place any heavy objects on the appliance. 700830 5 / 26...
The following is an unintended use: – Storing flammable or explosive objects and liquids, such as ether, petroleum or adhesives; – Storing explosive materials, like sprays filled with flammable propellants; – Storing pharmaceutical products or preserved blood; – Storing live pets. 6 / 26 700830...
Declaration of Conformity The appliance meets the currently applicable standards and guidelines of the European Union. We confirm the above in the EC Declaration of Conformity. We may provide relevant Declaration of Conformity upon request. 700830 7 / 26...
– in a location protected against mechanical shocks. In the case of extended storage (over three months), make sure you check the condition of the packaging and the parts regularly. If needed, replace the packaging with a new one. 8 / 26 700830...
Technical Data Technical Data Technical Specifications Name: Bakery refrigerator 235L 700830 Art. No.: Material: stainless steel Inner material: stainless steel Volume, in l: Temperature range, min.–max., in °C: 2 - 8 Ambient temperature, min.–max., in °C: 10 - 30 Amount of coolant, in kg:...
Page 12
More information on the appliance is available in our website www.bartscher.com or, pursuant to the Regulation (EU) 2015/1095, in our product data base at https://energy-label.ec.europa.eu/. Enter article number for a given model. 10 / 26 700830...
4. Digital temperature controller 5. Housing 6. Door with flush handle 7. Door seal 8. Fan 9. Internal LED lighting 10. Rack with guide rails 11. Oven sheet (4 pcs) 12. Feet (4 pcs) 13. Bottom working surface 700830 11 / 26...
– Lift the appliance with the lift truck and move it to the planned installation location. Be careful not to damage the appliance. Control the stability in order not to lose the balance of the appliance. 12 / 26 700830...
Page 15
The following tools are required: flat spanner No. 8 and 10, Phillips screwdriver. ATTENTION! Pull the mains plug out before you attempt to change the door hinge side. Do not place the appliance in horizontal position in order to change the door hinge side. 700830 13 / 26...
Page 16
Installation and operation 14 / 26 700830...
If possible, in the event of a sudden power failure, avoid opening doors in order to avoid loss of cool air. • If the appliance is switched off for a longer period of time, the door of the cooler should remain open. 700830 15 / 26...
Page 18
Displaying the minimum stored temperature, selection of parameter code in programming mode, decreasing the displayed value Switching the appliance on or off Switching the internal LED lighting of the appliance on or off 16 / 26 700830...
Page 19
Displaying the Lowest Temperature 1. Press and release the key. The 'Lo' message is displayed, followed by the minimum registered temperature. 2. To restore standard display, press the key again and hold it for 5 seconds. 700830 17 / 26...
Page 20
1. If there is a need for the change of automatic defrosting phases, press the key and hold it for more than 2 seconds. The digital display shows the symbol. The defrosting cycle is immediately initiated; in such a case, the subsequent defrosting cycle is executed after 6 hours. 18 / 26 700830...
Page 21
(value of temperature inside the appliance) NOTE! Subsequent settings or parameter changes should be introduced by service personnel only. Switching the Internal LED Lighting On/Off 1. Press and release the key. 700830 19 / 26...
10. Clean the door and the door seal of the appliance with a soft, damp cloth. To end with, dry the door and door seal thoroughly. 11. After cleaning, leave the door open for the appliance to dry completely. 20 / 26 700830...
Page 23
The following operations should be regularly performed by a qualified specialist: – cleaning the condenser with suitable tools (vacuum cleaner or soft brush); – checking of electrical connections; – checking of the thermostat and the sensor; – checking of door and door seal. 700830 21 / 26...
Door is not closed properly Close the door tightly; limit the or it has been opened for door opening time to too long minimum Damaged or deformed door Contact the service company seal 22 / 26 700830...
Page 25
Clogged condensed water Clear the condensed water drain opening drain opening Condensed water drip tray Contact the service company damaged (if applicable) Condensed water overflows Empty the condensed water the drip tray (if applicable) drip tray regularly 700830 23 / 26...
Electrical appliances should be returned to designated collection points. Coolant The propellant used in the appliance is flammable. It should be utilised pursuant to national regulations in force. 24 / 26 700830...