Axis C1310-E User Manual page 7

AXIS C1310-E Network Horn Speaker
Additional settings
Note
Some email providers have security filters that prevent users from receiving or viewing large attachments, from
receiving scheduled emails and similar. Check the email provider's security policy to avoid delivery problems and
locked email accounts.
2.8 Click Save.
3. Set up the automated speaker test:
3.1
3.2
3.3
3.4 Under Condition, select Schedule and select from the trigger list
3.5
3.6
3.7 Click Save.
4. Set up the condition for sending an email when the speaker test fails:
4.1
4.2
4.3
4.4 Under Condition, select Speaker test result.
4.5 Under Speaker test status, select Didn't pass the test.
4.6
4.7
4.8
Set up direct SIP (P2P)
Use peer-to-peer when the communication is between a few user agents within the same IP network and there is no need for extra
features that a PBX-server could provide. To better understand how P2P works, see Peer-to-peer SIP (P2PSIP) on page 11 .
For more information about setting options, see SIP on page 26.
1. Go to System > SIP > SIP settings and select Enable SIP.
2. To allow the device to receive incoming calls, select Allow incoming calls.
3. Under Call handling, set the timeout and duration for the call.
4. Under Ports, enter the port numbers.
- SIP port – The network port used for SIP communication. The signaling traffic through this port is non-encrypted.
The default port number is 5060. Enter a different port number if required.
- TLS port – The network port used for encrypted SIP communication. The signaling traffic through this port is
encrypted with Transport Layer Security (TLS). The default port number is 5061. Enter a different port number
if required.
Go to the device interface > System > Events > Rules.
Click Add a rule.
Enter a name for the rule.
Under Schedule, select your schedule ("Daily at 6pm").
Under Action, select Run automatic speaker test.
Go to the device interface > System > Events > Rules.
Click Add a rule.
Enter a name for the rule.
Under Action, select Send notification to email.
Under Recipient, select your recipient ("Speaker test recipients")
Enter a subject and a message, and click Save.
7