Axis C1310-E User Manual page 37

AXIS C1310-E Network Horn Speaker
Specifications
Buttons
Control button
The control button is used for:
• Calibrating the speaker test. Press and release the control button and a test tone is played.
• Resetting the product to factory default settings. See Reset to factory default settings on page 33.
Microphone disable switch
For location of the microphone disable switch, see Product overview on page 36.
The microphone disable switch is used to mechanically turn the microphone ON or OFF. The factory default setting for this switch
is ON.
Connectors
Protective earth terminal
DANGER
Risk of electric shock. The product shall be grounded using a grounding wire. Make sure both ends of the grounding wire
are in contact with their respective grounding surfaces.
Make sure the grounding wire is as short as possible to make the current path as short as possible.
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NOTICE NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see the Installation Guide at www.axis.com.
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface, trough an event or from the product's webpage.
4-pin terminal block
Function
DC ground
Pin Notes
1
37
Specifications
0 V DC