Axis C1310-E User Manual page 6

AXIS C1310-E Network Horn Speaker
Additional settings
Additional settings
Calibrate and run a remote speaker test
You can run a speaker test to verify from a remote location that a speaker is working as intended. The speaker performs the test by
playing a series of test tones that are registered by the built-in microphone. Every time you run the test, the registered values are
compared with the values that were registered during the calibration.
Note
The test must be calibrated from its mounted position at the installation site. If the speaker is moved or if its local
surroundings change, for instance if a wall is built or removed, the speaker should be re-calibrated
During calibration, it is recommended that someone is physically present at the installation site to listen to the test tones and
ensure that the test tones are not muffled or blocked by any unintended obstructions in the speaker's acoustic path.
1. Go to the device interface > Audio > Speaker test.
2. To calibrate the audio device, click Calibrate.
Note
Once the Axis product is calibrated, the speaker test can be run at any time.
3. To run the speaker test, click Run the test.
Note
It is also possible to run the calibration by pressing the control button on the physical device. See Product overview on page
36 to identify the control button.
Send an email if a speaker test fails
In this example the audio device is configured to send an email to a defined recipient when a speaker test fails. The speaker test
is configured to be performed 18:00 every day.
For more information about setting up rules, visit Get started with rules for events.
1. Set up a schedule for the speaker test:
1.1 Go to the device interface > System > Events > Schedules.
1.2 Create a schedule that starts at 18:00 and ends at 18:01 every day. Name it "Daily at 6pm".
2. Create an email recipient:
2.1 Go to the device interface > System > Events > Recipients.
2.2 Click Add recipient.
2.3 Name the recipient "Speaker test recipients"
2.4 Under Type, select Email.
2.5 Under Send email to, enter the email addresses of the recipients. Use commas to separate multiple addresses.
2.6 Enter the details for the email account of the sender.
2.7 Click Test to send a test email.
6