Pride J6 with NE Electronics Technical Troubleshooting Manual page 11

NOTE: System Lock must be enabled (ON) in order to lock out the Q-Logic joystick module (1). Refer to the pro-
gramming text. See figure 11.
Solution:
Use the following procedure to release the Q-Logic joystick module (1) from System Lock mode:
1. Turn on the power to the Q-Logic joystick module (1).
2. Deflect the joystick to the full forward position until an audible beep is heard.
2. Deflect the joystick to the full rearward position until an audible beep is heard.
4. Release the joystick. The LCD screen returns to normal.
NOTE: There are two ways to perform a System Lock:
1. Hold down the mode switch until the system shuts down.
2. Select "System Lock" in the AUX menu (if one is used).
Using the mode switch for system lock:
1. Turn on the power to the Q-Logic joystick module (1).
2. While the power is on, push and hold the on/off mode select lever forward until the unit shuts off.
3. The display states "System Lock." After several seconds, the system will then power itself off.
J6 with NE, NE+, and Q-Logic Electronics Technical Troubleshooting Guide www.pridemobility.com 11