Pride J6 with NE Electronics Technical Troubleshooting Manual page 26

ERROR CODE
#1 to #6: Software Fault
#19: Communication Fault
#23: Communication Fault
#36: Joystick Not Centered
#37: Joystick Connection
#105: Low Battery Fault
#192: Motor 1 Disconnected
#193: Motor 2 Disconnected
#203: Brake 1 Disconnected
#204: Brake 2 Disconnected
#229: Module Missing or
Defective
Table 3. J6 with Q-Logic Electronics Error Codes*
* Refer to the Q-Logic Error Code Reference Guide for additional error codes.
DIAGNOSIS
Generic software or module error. Power joystick off/on. Check all module
Communication to a module
failed.
BUS cable unplugged while driv-
ing. BUS cable defective. Hard-
ware failure.
Joystick not centered at power up. Release joystick. Power joystick off/on.
Joystick disconnected or defec-
tive.
Battery voltage below nominal
operating range limit. The battery
is not sufficiently charged.
Motor connector unplugged.
Motor wiring open. Defective
motor.
Motor connector unplugged.
Motor wiring open. Defective
motor.
Motor connector unplugged.
Brake wiring open. Brake defec-
tive. The brake voltage is set too
low.
Motor connector unplugged.
Brake wiring open. Brake defec-
tive.
Device not connected. Device is
defective. Wrong system configu-
ration data.
SOLUTION
connections. Update module software.
Power joystick off/on. Check all cable
connections. Update module software.
Power joystick off/on. Check all BUS cable
connections. Unplug device after device
from BUS cable until fault is resolved.
Ensure joystick is connected. If so,
replace joystick.
Charge battery.
Check motor brake connector. Check
motor wiring and resistance.
Check motor brake connector. Check
motor wiring and resistance.
Check motor brake connector. Check
brake wiring and resistance.
Check motor brake connector. Check
brake wiring and resistance.
Reconnect device. Replace device. Save
system configuration.