Electrolux EHF6342XOK User Manual page 14

14 www.electrolux.com
Problem
The hob deactivates.
Residual heat indicator
does not come on.
Automatic Heat Up does
not operate.
You cannot activate the
outer ring.
There is a dark area
on the multiple zone.
The sensor fields become
hot.
comes on.
and a number come on. There is an error in the
You can hear a constant
beep noise.
comes on.
Possible cause
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
The zone is hot.
The highest heat setting is
set.
You decreased the heat
setting to 0.
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large
or you put it too near to the
controls.
Child Safety Device or
Lock operates.
hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
Remedy
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
Start from 0 and increase
the heat setting.
First, activate the inner ring
by changing the heat set‐
ting.
Put large cookware on the
rear zones, if possible.
Refer to "Daily use".
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If comes on
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Remove the
fuse, wait one minute, and
insert the fuse again.