Page 2
■Content of package ■Adjuster(Adjuster comes already fixed to the chair. )...
Page 4
Important! In the cae of ★ mark, attach/take off the parts Flange Adjuster nut 8 pcs. cover (black) before taking the chair off the crate. Adjuster cover (chrome plated) ●The gap from floor to the fall-prevention bar should be within 10mm. If the fall-prevention bar is fixed too high, the chair will easily fall over. ...
Page 5
■Caution when carrying the chair Always hold the bottom of the base Carrying the chair by holding the base cover, foot switch, or cushions may cause breakage of the chair or injury to the person carrying it. Also, holding the fall-prevention bar may pinch your fingers between the floor.Also, carrying the chair tilted may cause breakage of the adjuster cover or damage the floor. Basin neck height...
Page 8
sure to return the cover back to its position). □Is the step adjuster □Visually check that the adjuster screw is □Rusted adjuster screw may cause product breakage screw not rusted? not rusted. (Check by moving the adjuster or falling accidents. Stop using the product and cover up & down. After checking, make sure contact your nearest dealer or Takara Belmont. to return the cover back to its position. □Has no air entered into □Check that the chair will not sink when a □Customers may not be able to get in/out of the the hydraulic system? load is applied to the seat at its lowest chair safely. Contact your nearest dealer or (If holding the chair by position. Takara Belmont. the armrest or backrest when carrying may cause air to enter into the system). TAKARA BELMONT CORPORATION 1-1, 2-Chome, Higashi-shinsaibashi,Chuo-ku,Osaka,Japan TEL : (06) 6212-3523 FAX : (06) 6211-5745 Printed in Japan...
Need help?
Do you have a question about the MIRAKU SC-S81XL and is the answer not in the manual?
Questions and answers