Installing Handwheel Handles - Grizzly G8688 Owner's Manual

Installing Handwheel
Handles
components and Hardware Needed:
handwheel handles .......................................... 2
To install the handwheel handles:
1. using a screwdriver and 14mm open end
wrench, thread the handwheel handles into
the longitudinal and cross feed handwheels
(see figure 9).
2.
tighten the nut securely against the
handwheel while ensuring the handle can
spin freely around the bolt with minimal end
play.
handwheel
handles
figure 9. installing the handwheel handles.
Model g8688 (Mfg. 3/09+)
Qty
Cross Slide Feed
figure 10. Flipping the handle.
3.
the cross slide feed has been turned around
for shipment. With a 5mm hex wrench, remove
the cap screw, turn the handle around, and
retighten the cap screw (see figure 10).
-15-