Advertisement
4.. Separate. the. two. pieces. of. the. mounting.
assembly,. then. place. the. table. bracket. over.
the. lip. of. the. table. trough,. as. shown. in.
Figure 5.
Table
Bracket
Figure 5..Table.bracket.mounted.on.the.lip.of.
the.table.trough.
5.. Mark.the.points.on.the.table.where.the.table.
bracket.hex.bolts.make.contact,.then.remove.
the.bracket.from.the.table.
6.. Spot.drill.the.points.marked.in.Step 5.to.give.
the.hex.bolts.a.small.spot.to."bite".the.table.
without.slipping.on.the.rough.cast.surface.
7.. Set.the.bracket.back.on.the.table.and.tighten.
down.the.hex.bolts.
8.. install. the. mounting. bracket. onto. the. power.
feed.assembly.with.the.two.cap.screws.pro-
vided,. as. shown. in. Figure 6,. but. do. not. yet.
fully.tighten.them.
Mounting
Bracket
Figure 6..Mounting.bracket.installed.onto.the.
power.feed.unit.
H8370.(Mfg..Since.7/11)
9.. Position. the. assembly. from. Step 8. onto. the.
table. bracket. so. that. the. teeth. of. the. drive.
gear. and. the. leadscrew. gear. mesh. exact-
ly,. then. tighten. the. mounting. bracket. cap.
screws. and. the. table. bracket. hex. bolts. (see.
Figures 7–8).
Drive.Gear
Figure 7..Power.feed.drive.gear.and.leadscrew.
gear.properly.meshed.
Figure 8..installing.the.power.feed.and.mounting.
bracket.assembly.onto.the.table.bracket.
be sure there is enough running clearance
between the table, spindle, vise/clamps, or
jigs before turning the power feed ON. be
aware that all of these objects represent
potential pinch points.
leadscrew.Gear
-3-
Advertisement
