Specifications
Motor ................................................. 110V 60Hz
Speed ............................................... 4–160 RPM
Maximum Torque .................................650 in./lb.
Inventory
Refer to Figure 1 and the table below to inventory
the contents of the shipping box.
REF PART #
DESCRIPTION
1
PH8371001 MOUNTING BRACKET
2
PH8371002 POWER FEED & LIMIT SWITCH ASSY
3
PH8371003 COMPLETE BOLT BAG
4
PH8371004 LIMIT STOP ASSEMBLY
5
PH8371005 BEVEL GEAR BRASS
Bolt Bag Inventory
Spacer Set 34mm .............................................. 1
Spacer Set 16mm .............................................. 1
Bushing Spacer ................................................. 1
Slotted Flat Washer ........................................... 1
Special Hex Nut
⁄
"-20 ...................................... 1
1
2
Cap Screws
⁄
"-20 x 1" ..................................... 2
1
4
Roll Pins 5.1 x 14mm ........................................ 2
Phillips Head Screws #10-24 x
Flat Washers 5mm ............................................ 2
Cable Clamps .................................................... 2
Tie Wraps .......................................................... 2
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
Qty
⁄
" .................... 2
3
8
COPYRIGHT © MARCH, 2008 BY GRIZZLY INDUSTRIAL, INC.
#TS10534 PRINTED IN TAIWAN
MODEL H8371
POWER FEED
FOR KNEE MILLS
INSTRUCTIONS
�
�
�
Model H8371 inventory.
Figure 1.
If any nonproprietary parts are missing (e.g. a
washer or a spacer), we will gladly replace them;
or for the sake of expediency, replacements can
be obtained at your local hardware store.
If you need help with your new power feed, call
our Tech Support at: (570) 546-9663.
Be sure there is enough running clearance
between the table, spindle, vise/clamps, or
jigs before turning the power feed ON. Be
aware that all of these objects represent
potential pinch points.
�
�