Advertisement
Quick Links
Taper Attachment for G4016
Gear Head Lathe
MODEL H0775
INSTRUCTION SHEET
COPYRIGHT © AUGUST, 2004 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#EM6565 PRINTED IN CHINA
Advertisement
Related Manuals for Grizzly H0775
Summary of Contents for Grizzly H0775
- Page 1 Gear Head Lathe MODEL H0775 INSTRUCTION SHEET COPYRIGHT © AUGUST, 2004 BY GRIZZLY INDUSTRIAL, INC. WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC. #EM6565 PRINTED IN CHINA...
- Page 2 PARTS INVENTORY Figure 1. Main contents. G. Roll Pins ............. 2 The Model H0775 Taper Attachment was carefully H. Washers 8mm ..........4 packed when it left our warehouse. If you discover that the taper attachment is damaged after you Washer 17mm ..........
- Page 3 Bearing Dust Cover Thrust Bearing The H0775 comes carefully packaged and it is coated with import grease to protect it from rust. Figure 2. Cross Lead Screw components. You will need to clean all pieces thoroughly prior to installation and use.
- Page 4 Remove the 6 philips head screws from the top cover plate of the main body. Set the Threaded screws and cover aside for later use in reas- Holes sembling the main body. Remove the end block and slide block from the main body by pulling up.
- Page 5 16. With the main body loosely fastened (see 19. Attach the deadman to the lathe bed (Figure Figure 6), move the slide block back and 8). The deadman is composed of a solid forth, by either pulling/pushing on the lead cast bracket and a loose clamping jaw.
- Page 6 OPERATION & ADJUSTMENTS Angle Adjustments There are two gib screws, for making adjust- ments, located just above and behind the The taper angle is adjusted by loosening the two dovetail on the main body. To tighten the gib, cap screws at the ends of the dovetail slide on loosen the gib screw on the left (as viewed the taper attachment.
- Page 7 H0775 Parts Breakdown and List from G4016 from G4016 from G4016 from G4016 from G4016...
- Page 8 H0775 Parts List REF PART # DESCRIPTION REF PART # DESCRIPTION P51101 P51101 P51101 THRUST BEARING 51101 THRUST BEARING 51101 THRUST BEARING 51101 PH0775020 PH0775020 PH0775020 THREADED ROD THREADED ROD THREADED ROD PH4016447 PH4016447 PH4016447 SPACER M12 X 8 SPACER M12 X 8...