An712 Module Management And Control - Toshiba V Series User Manual

Chapter 5 Application Interface

5.9 AN712 Module Management and Control

5
74
The AN712 management and control message transmission illustrated in figure 5-19 is
used for sending instruction messages to the AN712 module.
o m m a n d /
R e s p o n s e
Figure 5-19 AN712 Management and Control Message Basic Format
The socket data header identifies socket data. It is where command/response set for
system management (SMG) can be specified.
Auxiliary information is unused.
Management and control identifier indicates the management and control function within
the AN712 module.
Status indicates the state of processing an added message in case of response
messages. Status is unused for command messages, in which case 0 must be specified.
The value 0 indicates that the command has been processed normally. Other than the
value 0 is an error code indicating that the request command has not been processed
normally.
A list of management and control messages usable for the AN712 module is shown in
Table 5-3. The parameters in messages for each command and response are described
in section 5.9.1 and subsequent pages.
Table 5-3 AN712 Management and Control Messages
Name
Scan transmission block
registration
Scan transmission cycle
setting
Scan transmission healthy
monitor cycle setting
Scan transmission start/stop SMG RQ/SMG RR
Station status control
B y t e a d d r e s s
5
+ 0 0 ( 0 x 0 0 ）
S o c k e t d a t a h e a d e r ：
' A N 7 1 2 S M G R Q
' A N 7 1 2 S M G R R
+ 0 4 ( 0 x 0 4 ）
+ 0 6 ( 0 x 0 6 ）
+ 0 8 ( 0 x 0 8 ）
+ 0 ( 0 x 0 A ）
+ 2 ( 0 x 0 C ）
A u x i l i a r y i n f o r m a t i o n
+ 4 ( 0 x 0 E ）
+ 6 ( 0 x 0 ） M a n a g e m e n t a n d c o n t r o l i d e n t i f i e r
+ 8 ( 0 x 2 ）
+ 2 0 ( 0 x 4 ）
+ 2 2 ( 0 x 6 ）
A N 7 1 2 m a n a g e m e n t a n d c o n t r o l
c o m m a n d o r r e s p o n s e
Header
SMG RQ/SMG RR To set high, medium, low speed scan
transmission blocks
SMG RQ/SMG RR To set high, medium, low speed scan
transmission cycles
SMG RQ/SMG RR To set high, medium, low speed scan
transmission block healthy monitor
cycles
To start/stop high, medium, low speed
scan transmission
SMG RQ/SMG RR To instruct ADMAP station status control
(Inring, off-ring, online, standby)
model 3000 ADMAP-5M AN712 Module User's Manual
0
'
'
S t a t u s
Description