Toshiba V Series User Manual page 32

Chapter 3 Settings
3
18
(2) Scan data access
In accessing scan data, double-click the block you wish to access on the LAN
transmission map] screen so that 64 words of data are shown for that block.
By selecting a block No., the desired block can be accessed for data. Select either
decimal or hexadecimal for the desired form of display.
To write data at an address, double-click the desired data to enter it (check that it is now
shown in red), the select [Write (W)] to write the desired data.
(3) Scan unhealthy map clear
Once unhealthy status is detected, the scan unhealthy map keeps that status. [Scan
unhealthy clear] is for clearing that map to check that it is reset.
It can be cleared as follows:
Click [Monitor stop]. Then, select [Scan unhealthy clear] and execute it.
(4) Duplicated SA clear
Duplicated transmission occurs if two or more nodes are transmitting to duplicated scan
transmission blocks.
The background is shown in red to indicate a duplicated state. Two numbers are shown
with the corresponding block, indicating which nodes are in a duplicated state.
When the duplicated state is cleared in the system, check the display again to confirm
normal operation.
Once a duplicated state is detected, the duplicated transmission map keeps that status.
Clear the map to check that it is reset in the duplicated transmission SA area.
It can be cleared as follows:
Click [Monitor stop]. Then, select [Duplicated transmission SA clear] and execute it.
model 3000 ADMAP-5M AN712 Module User's Manual