Toshiba V Series User Manual page 18

Chapter 2 Names and Functions of Parts
2
4
The main function of the parts are shown below.
(1) Status LEDs
LED
RUN (green) Hardware operation status
ON: Module operating
OFF: Module trouble
HLTH (green) Module transmission status
ON: Module transmitting
OFF: Wrong switch setting
SCAN (green) Scan transmission status
ON: Scan transmission under way
OFF: No scan transmission
RING (green) Token ring status
ON: Token ring
CD-A (green) ADMAP transmission line A status
ON: Transmission frame being received
CD-B (green) ADMAP transmission line B status
ON: Transmission frame being received
(2) Station address setting switches (STN-H, STN-L)
ADMAP node address can be set in hexadecimals using these switches as
described in Chapter 3, Settings.
(3) Operation mode setting switches (STC)
ADMAP operation modes can be selected using these 8-bit DIP switches as
described in Chapter 3, Settings.
(4) ADMAP maintenance console connector (SC-CN)
For connection to the ADMAP maintenance console with RS-232C interface.
(5) ADMAP bus connectors (CN-A, CN-B)
CN-A is for bus A and CN-B for bus B.
Table 2-1
Description
model 3000 ADMAP-5M AN712 Module User's Manual
Normally
ON
ON
ON
ON
ON