Inspection; Daily Inspection; Periodic Inspection - Toshiba V Series User Manual

Chapter 8 Maintenance and Inspection

8.1 Inspection

8.1.1

Daily inspection

8
8.1.2

Periodic inspection

94
Take the following steps in daily inspection.
Front Panel
(1) LED
Check each LED that it is not difficult to see. If it is, clean it with a soft cloth.
Exercise care not to change the switch positions.
(2) ADMAP connector
Check the connector that it is connected as specified in Process LAN ADMAP
Installation and Wiring Manual (6F8C0479) and that the cable connection is normal.
Check that the cable is not about to come off and that it appears normal. Check that
the wiring is as specified in the Installation and Wiring Manual as to bends, radius,
route, etc.
If anything abnormal is found, contact the Toshiba service office concerned.
Ventilation holes
Check the front panel and top of the product that the ventilation holes are free of dust and
dirt. If the ventilation holes are clogged up with dust or dirt, remove it with a vacuum
cleaner, for example, then clean them with a soft cloth.
Indoor environment
Check the place where the product is installed that its temperature and humidity meet the
specified temperature and humidity ranges of the product (Table A-1, General
Specifications).
To prevent accidents and ensure safe operation over a long period of time, a periodic
inspection of at least once a year is recommended.
It is also recommended that expendable parts be replaced periodically. (See the section
on expendable parts.) For periodic inspection, consult the Toshiba service office
concerned.
model 3000 ADMAP-5M AN712 Module User's Manual