Drive Belt - Toro MB TX 2500 Operator's Manual

Drive Belt

Inspecting the Drive Belt
1. Park the machine on a level surface, move the motion-control levers to the N
position, engage the parking brake, and lower the hopper.
2. Shut off the engine, and remove the key. Allow the engine to cool.
3. Release the cushion and remove the fuel tank.
4. Inspect the belt. Replace the belt if it is worn.
Note:
burn marks, and cracks on the belt.
Replacing the Drive Belt
1. Park the machine on a level surface, move the motion-control levers to the N
position, engage the parking brake, and lower the hopper.
2. Shut off the engine, and remove the key. Allow the engine to cool.
3. Release the cushion and remove the fuel tank.
4. Raise the rear of the machine and support the machine on jack stands.
5. Remove the skid plate.
6. Remove the extension spring.
Maintenance: Drive System Maintenance
The signs of a worn belt include squealing while the belt is rotating, frayed edges,
G189546
G325648
Page 5–19
EUTRAL
Extension spring
Belt
EUTRAL
Rear bolt (2)
Skid plate
Side bolt (4)
-
LOCK
-
LOCK
3451-705A