Lifting the Machine
Ensure that the hopper is empty before lifting the machine.
1. Place the platform in the raised position.
2. Hoist the machine using the 2 lift points under
the hopper
. Tilt the hopper forward to locate the 2 lift
loops and attach a chain or straps at each of
the loops.
Note:
to properly balance the unit.
Releasing the Cushion for Rear Access
1. Lower the platform.
2. Loosen the twist knobs
3. Remove the cushion
platform.
4. Perform any maintenance or adjustment on
the machine.
5. Raise the cushion, and slide it onto the pins on
both sides of the machine.
6. Tighten the twist knobs.
3451-705A
and the 2 rear tie-down points
Take up the slack in the chain or straps
on each side of the machine.
and lower it to the
G194436
g032556
Page 5–4
Maintenance: Pre-Maintenance Procedures