Drive System Maintenance; Track Service - Toro MB TX 2500 Operator's Manual

Replacing a Fuse (continued)
1. Release the cushion from the rear of the machine.
2. Pull out the fuse to remove or replace it.
3. Install the cushion to the rear of the machine.
Note:
If a fuse blows a second time, check the component/circuit for a malfunction or a short or
contact your Authorized Service Dealer.

Drive System Maintenance

Track Service

Cleaning the Tracks
1. Park the machine on a level surface, move the motion-control levers to the N
position, engage the parking brake, and lower the hopper.
2. Shut off the engine, and remove the key. Allow the engine to cool.
3. Lift/support the side of the machine to be worked on so that the track is 7.6 to 10 cm (3
to 4 inches) off the ground.
Maintenance: Drive System Maintenance
G376375
Ensure that the correct-size fuse is installed.
Page 5–15
Main power fuse (15 A)
Auxiliary power fuse (15 A)
Logic fuse (7.5 A)
EUTRAL
-
LOCK
3451-705A