Lubrication; Greasing The Machine - Toro MB TX 2500 Operator's Manual

Using the Cylinder Lock (continued)
1. Start the machine.
2. Fully raise the hopper.
3. Shut off the engine.
4. Remove the cotterless pins securing the
cylinder lock.
5. Place the cylinder lock on the posts inside the
machine frame and secure with the cotterless
pins.
6. Lower the hopper.

Lubrication

Greasing the Machine

Grease Type: General-purpose grease.
Note:
Remove the blue protection caps, if applicable, before greasing and replace when
finished.
1. Park the machine on a level surface and engage the parking brake.
2. Shut off the engine and allow the engine to cool.
3. Clean the grease fittings with a rag.
4. Connect a grease gun to each fitting.
5. Pump grease into the fittings until grease begins to ooze out of the bearings
(approximately 3 pumps).
6. Wipe up any excess grease.
3451-705A
G375954
G376192
Page 5–6 Maintenance: Lubrication