Removing Debris From The Machine; Lowering The Hopper Without Power - Toro MB TX 2500 Operator's Manual

After Operation Safety (continued)
• Do not touch parts that may be hot from operation. Allow them to cool before attempting
to maintain, adjust, or service the machine.
• Clean debris from drives, mufflers, and the engine to help prevent fires. Clean up oil or
fuel spills.
• Use care when loading or unloading the machine into a trailer or truck.

Removing Debris from the Machine

1. Park the machine on a level surface, move the motion-control levers to the N
position, engage the parking brake, and lower the hopper.
2. Shut off the engine and remove the key. Allow the engine to cool.
3. Clean the inside of the hopper using a hose.
Do not use a hammer to remove material from the inside of the hopper; this may
cause damage to the machine.
4. Clean any debris from under the hopper.
5. Wipe away debris from the air cleaner.
6. Clean any debris buildup on the engine and in the transmission with a brush or blower.
Blow out dirt rather than wash it out. If you use water, keep it away from electrical
parts and hydraulic valves. Do not use a high-pressure washer. High-pressure
washing can damage the electrical system and hydraulic valves or deplete grease.

Lowering the Hopper without Power

1. Install the cylinder lock.
2. Ensure that the tub is empty.
3. Place a large drain pan under the hydraulic-
manifold block.
3451-705A
IMPORTANT
IMPORTANT
G384891
Page 4–9
-
EUTRAL LOCK
Operation: After Operation