Shutting Off The Engine; Operator Platform - Toro MB TX 2500 Operator's Manual

Starting the Engine (continued)
5. When the engine starts
Do not engage the starter for more than 5 seconds at a time. If the engine fails to start,
allow a 15-second cool-down period between attempts. Failure to follow these
instructions can burn out the starter.

Shutting Off the Engine

1. Move the throttle between the F
2. Engage the parking brake.
3. Turn the key switch to the O

Operator Platform

You can use the machine with the platform in the up or down position.
The operator platform is heavy and may cause injury when you raise or lower it.
Carefully lower or raise the operator platform, as suddenly dropping it could injure
you.
• Do not put your hands or fingers in the platform-pivot area when lowering or
raising the operator platform.
• Make sure that the platform is supported when you pull the latch pin out.
• Make sure that the latch secures the platform when folding it up. Push it tight
against the cushion for the latch pin to lock into place.
• Keep bystanders away from the machine when raising or lowering the platform.
Operate the machine with the platform up for the following conditions:
• Using the machine near drop-offs
• Using the machine in small areas where the machine is too large
• Areas with low-hanging branches or obstacles
Operation: During Operation
, disengage the choke
IMPORTANT
G375756
and S positions.
AST LOW
position and remove the key.
FF
WARNING
Page 4–6
.
3451-705A