Smeg K43X Instruction Booklet page 9

Table of Contents

5.3 Air connection systems

5.3.1 DUCTING version

The hood is supplied in the filter version. Follow the instructions below to set-up the hood in the

simply have to reset the controls, as indicated in the "Hood operation" section.

5.3.2 FILTER version

The hood is supplied in the filter version. After 100 hours of hood operation, the lights of buttons

and

will flash to indicate that the active carbon filter should be replaced. Contact the

nearest authorized SMEG service centre to purchase a replacement activated carbon filter: model

FLT6. Follow the instructions below to replace it. Fig. 5.3.1 - 1) Unscrew the 2 screws from the casing

– 2) Remove the casing – 3) Replace the activated carbon filter –2) Replace the casing over the motor

– 1) Screw the 2 screws back onto the casing. Test by turning on the hood and pressing the maximum

speed button

. The old filter should be disposed of in accordance with the current regulations

in the country of installation.

Instructions for the installer

ducting version. Fig. 5.3.1 – 1)

Unscrew 2 screws on the casing – 2)

Remove the casing – 3) Remove the

activated carbon filter. Fig. 5.3.2 – 4)

Insert 2 half valves into the motor

inlet – 5) Replace the casing over the

motor – 6) Screw the 2 screws back

onto the casing. Fig. 5.3.3 – 7) Connect

the motor to the fumes outlet with a

conduit having an internal diameter of

150 mm. Test by turning on the hood

and pressing the maximum speed

button

. Fig. 5.3.4 – 8) Position the

flue above the hood – 9) Secure the

casing with two screws. After 100

hours of hood operation, the lights of

buttons

until the reset is complete. In the

ducting configuration, because there

is no activated carbon filter, you

and

will flash

Table of Contents