Advertisement
Quick Links
Installation, Use
and Maintenance
Manual
OVEN HOOD SCF00032
Introduction
Dear Customer, we hereby thank you for
choosing our Oven Hood
and hope you will be satisfied with our product.
1. Instructions
The following instruction manual is an integral
part of the equipment
and must be at the operators' disposal for
advice until the end of the life
cycle of the product.
Before carrying out any operations, carefully
read the information
contained in the manual about safe installation,
use and maintenance.
The equipment is only intended for the use it
has been designed for,
by qualified and skilled personnel.
Installation, maintenance and repair operations
must only be carried
out by an authorized technical service centre or
qualified personnel, in
compliance with the regulations in force and
according to the instructions
provided by the manufacturer.
When using it for the first time, make sure that
the hood conveyor
connected to the exhaust ducts of the oven is
positioned correctly, to
prevent vapour leakage. It is recommended to
make sure that the
connection between the ducts and the oven is
well sealed every time the
hood or the oven on which it is installed are
moved.
The equipment must be earthed in accordance
with the safety
regulations of the electrical system.
The plug to be connected to the power cable
must be compliant with
the regulations in force.
Do not block the openings, the heat ventilation
and exhaust slits.
Use the hood at an ambient temperature
between +5 °C and +35 °C.
This appliance is intended for professional use
and complies with the
EC directives in force. The appliance functions
as a condenser for the
exhaust vapours of the oven, therefore any
other use of the device is
improper.
The Manufacturer refuses all responsibility for
direct and indirect
damage caused by improper installation,
tampering with, inadequate
maintenance, improper use and failure to
comply with the regulations
contained in the instruction manual.
2. Installation
All the materials, with the exception of silicone,
used for installation
must resist a temperature of 150 °C without
generating strains and/or
surface defects.
2.1 - Positioning
The Oven Hood must be positioned on the
oven, after must be
Advertisement
Related Manuals for Smeg SCF00032
Summary of Contents for Smeg SCF00032
- Page 1 It is recommended to Manual make sure that the connection between the ducts and the oven is OVEN HOOD SCF00032 well sealed every time the hood or the oven on which it is installed are Introduction moved.
- Page 2 fixed by the two brackets, that will be fixed to system. the rear oven’s back (Fig. 2.2 - Electrical connection The electrical must be carried out by qualified personnel in compliance with the European regulations fig.1 The Ove is replaced, it must be compatible with the maximum power of the 2.4 –...
- Page 3 cover or the front one. To remove the front 3.1 – Disassembling labyrinth filters mounted on the oven hood, fixed by screws cover unscrew the perimetric To disassemble the filters, grab and slide them (Fig. 4). screws (Fig. 3) and take care not to damage the upwards so that they electric cables when slip out of the lower guide.
- Page 4 out by authorized technical personnel. To ask for a spare part, indicate the hood model specified on the label. The spare parts that can be supplied are the following: I. Switch ON OFF black 10 A; II. Fan 7/7 - 145 W 4P; III.