Table of Contents
Advertisement
Intensive speed button. Lights up when the motor is running at speed 4*.
Light on / off button. Illuminated when on.
(*) Intensive function: The motor switches from speed 4 to speed 3 after about 7 minutes.
During the time in which the intensive function is active, the button flashes and the timer
function is not activated.
,
,
Pressing these buttons twice activates the timer. The timer function can only
be activated when the fan motor is on. Once activated, a 10-minute timer starts, when the
time elapses, the motor stops and the light switches off. The button flashes during this time.
The timer can be cancelled by touching the same button.
10.6 Light brightness adjustment function:
A brief touch of the
button for more than 1 second gradually increases the brightness to the maximum level and then
decreases it to the minimum level as long as the button is pressed. Release the button once you
have obtained the required brightness. This level of brightness will be saved in the non-volatile
memory so that it will be set each time the light is switched on by tapping the button once. Tapping
the light button twice when the light is off will set it to maximum brightness. The factory setting is
for maximum brightness.
10.7 Reset filter cleaning
After 100 hours of hood operation, buttons
clean the filter. To reset this warning, press the ON / OFF button for 5 seconds, the light of the ON
/ OFF button will flash once to indicate that the filter time has been reset.
10.8 24h Clean Air Function
The 24h Clean Air function allows you to clean the air in the room. To start the 24h function, press
and hold the
button for 3 seconds. The extraction hood will run at minimum speed for 10
minutes every hour (up to a maximum of 24 hours). The
the function is active. Briefly touching any button (apart from the
function.
Instructions for the user
button immediately switches the light on or off. Touching and holding this
,
and
will start to flash to remind you to
and
16
buttons will flash as long as
button) will disable the
EN
Advertisement
Table of Contents
