Troubleshooting
Problem
The attachment kicks up too much
material.
The attachment kicks up too little material.
The appearance of the field is poor.
There are squeaking noises during
operation.
The chains slip over the chain wheels.
Possible Cause
1. The working depth is too deep.
2. The driving speed is too fast.
1. The working depth is too shallow.
2. The driving speed is too slow.
3. The brush is worn.
1. The working depth is too deep.
1. The bearings need greasing or are
worn out.
1. The chains tension is incorrect.
2. The chains or chain wheels are worn.
16
Corrective Action
1. Use a more shallow working depth.
2. Use a slower driving speed.
1. Use a deeper working depth.
2. Increase the driving speed.
3. Replace the brush.
1. Use a more shallow working depth.
1. Grease the bearings using EP2 grease
or replace them.
1. Adjust the chain tension.
2. Replace the chains or chain wheels.