Table of Contents
Advertisement
About these products | Load-sensing control block SB11
4�4 Configuring the control block
1� Determine the desired order of the block segments (see chapter 4.2),
e.g. starting with the connecting plate.
2� Determine the tie rod length (see chapter 4.3).
4�5 Alignment of the control block on the working surface
The control block segments can be assembled / disassembled horizontally or
vertically.
▲ Vertical assembly
In case of horizontal assembly, the height difference of the individual block
segments should be compensated with a suitable underlayer from the fifth
control block segment in order to ensure safe orientation of the control block
segments to each other.
▲ Compensating height differences
▲ Horizontal assembly
RE 66177-10-R/2021-11-16, Bosch Rexroth AG
9/18
Advertisement
Table of Contents
