Representation Of Information; Symbols; Designations; Abbreviations - Bosch rexroth SB11 Assembly Instructions Manual

About this documentation | Load-sensing control block SB11
1�3 Representation of information
Uniform safety instructions, symbols, terms and abbreviations are used throughout
this documentation to ensure safe and proper use of the product. For clarification,
they are explained in the sections below.
1�3�1 Symbols
The following symbols indicate notices that are not safety-relevant but increase
understanding of the documentation.
Table 2: Meaning of symbols
Symbol Meaning
If this information is disregarded, the product cannot be used and/or
operated to its full extent.
▶
Single, independent action
1�
Numbered instruction:
The numbers indicate that the actions must be completed in order.
2�
3�
Black circle with white number:
Auxiliary marking for a better understanding.
White circle with black number: Position or assembly group with
reference to the parts list and to the graphics within a chapter.
White circle with black letters: Assembly group with reference to the
parts list and to the graphics within a chapter.
1�3�2 Designations
This documentation uses the following designations:
Table 3: Designations
Designation Meaning
SB11-EHS4 Control valve with pilot operated electro-hydraulic actuating unit
EHR11-EHS4 Control valve with CAN bus-controlled electro-hydraulic actuating unit
for electrohydraulic hitch control
Control valve Directional valve type SB
Hitch control valve Directional valve type EHR
1�3�3 Abbreviations
This documentation uses the following abbreviations:
Table 4: Abbreviations
Abbreviation Meaning
AP Connecting plate
EHR Electrohydraulic hitch control
EHS Electro-hydraulic actuating unit
EVR End valve (with LS signaling direction from left to right)
EP End plate
SVR Standard valve (with LS signaling direction from left to right)
RE 66177-10-R/2021-11-16, Bosch Rexroth AG
5/18