Assembly description | Load-sensing control block SB11
3� Align the control block segments to each other and pre-tension the nuts
in the order
4� Tighten the nuts
in the order
Tightening torque M
A
5�2 Control block disassembly
5�2�1 Preparation for disassembly
▶ Dismount the control block according to the parameters provided by the
machine manufacturer and place it on a clean and stable underlayer.
▶ The sealing and flange surfaces must not be damaged.
▶ The control block segments are to be numbered individually.
5�2�2 Disassembly, end plate
1� Loosen the nuts
by turning them counterclockwise and remove them from
the tie rods
... .
2� Remove the end plate
with a torque of approx. 5+1 Nm.
.
= 25.5+2.5 Nm
/ end valve
/ end valve
via the tie rods
RE 66177-10-R/2021-11-16, Bosch Rexroth AG
13/18
...
without jamming.