Option 55: Status Sounds - GE Simon Security System User Manual

Note
The phone number is auto-
matically stored after you've
pressed 26 digits. You will
not have to press DONE to
store the number. If the
number is less than 26 dig-
its, then DONE must be
pressed.
Simon Security System
6. Enter a phone number with the numbered keys. Press Test to enter a pause in
the phone number, press Add to enter a "*", and press Delete to enter a "#". Panel
announces each number selected.
7. Press DONE. Panel confirms entered phone number.
Delete disables the pager/voice event notification phone number. The phone number
will not be called in an alarm situation.
1. Open panel cover. Panel announces, Use numbered keys to enter ID.
2. Enter Access Code using the numbered keys. Panel announces, Please select from
Start Menu.
3. Press Delete from the Start menu. Panel announces, Select from main menu
4. Press Option #. Panel announces, Option 1, press again for next option or done to
select.
5. Press 43. Panel announces, Option 43, press again for next option or done to
delete.
6. Press DONE. Panel announces, Option 43 deleted.
The panel will call the pager/remote phone to indicate the follow-
ing:
Note
The panel will only call a remote phone for alarms and latchkey reports. The panel can call a
pager for all or some of the alarms/reports listed below. Ask your installer how your system is
programmed.
• No activity - A no activity alarm is called in if the programmed amount of time
passes, and no activity has occurred on your system. Examples of such are: the
panel is not subdisarmed, disarmed, sensors armed, a key has not been pressed or
a sensor has not been tripped. Tripping of non-intrusion chime sensors is not con-
sidered activity. The no activity time period is programmed by your installer.
• Latchkey - A latchkey report is called when the system is not disarmed by a pre-
determined time. The latchkey time is programmed by the user (Option 03).
Latchkey must be enabled when arming.
• Phone Test - A phone test report is called in when a phone test has been per-
formed.
• Disarming - A disarming report is called in when the system is disarmed. This
option is programmed by your installer.
• Arming - An arming report is called in when the system is armed. This option is
programmed by your installer.
• Fail to Open - A fail to open report is called in when the system is not disarmed
by the time programmed by the installer.
• Fail to Close - A fail to close report is called in when the system is not armed by
the time programmed by the installer.
• AC Power Failures - An AC power failure is called in after loss of power. To
avoid false alarms, your installer has programmed the panel to wait at least a few
minutes (or up to several hours) before calling in.
• AC Power Restore - A restore will be reported when power is restored.
• Alarms - Alarm reports include: Emergency, Intrusion, and Fire.
• Sensor Test - A report is sent when panel sensors are being tested.

Option 55: Status Sounds

Add allows you to set the volume for status sounds, such as arming beeps, trouble
beeps, and status beeps. The lowest volume setting is 1, the highest is 10.
1. Open panel cover. Panel announces, Use numbered keys to enter ID.
2. Enter Access Code using the numbered keys. Panel announces, Please select from
21