How To Use An Off-Site Phone; Using Touchpads And Keypads; Touchpads And Keypads; System Status - GE Simon Security System User Manual

How to Use an
Off-Site Phone
Note
You may have to perform
steps 1 & 2 more than once.
Ask your installer how your
system is programmed.
Using
Touchpads and
Keypads
Simon Security System
You may use an off-site phone to arm/disarm your panel, turn lights on and off, check
system status, or conduct an audio session (ask your installer if you have this feature).
¾ How to gain access to the Control Panel:
1. Call the panel phone number and let the phone ring once then hang up.
2. Wait 10 - 40 seconds and call the panel again.
3. The panel should answer on the first ring. The panel will announce "System On".
4. Press the * button on your telephone and you will hear "System Activated".
At this point you may perform the actions listed in the following table of phone com-
mands. CODE refers to the master and access codes programmed into your system.
Panel Function
DISARM
ARM Doors/Windows
ARM Doors/Windows with No Entry Delay
ARM Motions
ARM Motions with Latchkey
ARM Doors/Windows and Motions
ARM Doors/Windows with No Entry Delay
and Motions with Latchkey
Lights On/Off

System Status

AVM
Note
Phone commands cannot be used when the
panel is in AVM mode.
Hang Up
If you are interactive with your panel and the panel hangs up on you, the system is
calling in a report to the central monitoring station, pager or remote phone due to an
action made by you or someone at the security system site.
Touchpads and keypads are used to control the security system from any location
within or near your home.

Touchpads and Keypads

Interfacing with the system using a Remote Handheld Touchpad and Dialog QS1500
Touchtalk Interactive Keypad is similar to using the panel.
System Status
Press System Status once to hear information about your system from the panel. See
"Status Beeps".
ARM Doors & Windows
Press Arm Doors & Windows button once to turn the security system protection on
for all protected doors and windows.
Phone Commands
Phone Command
‚ + CODE + 1
‚ + CODE + 2
‚ + CODE + 2 + 2
‚ + CODE + 3
‚ + CODE + 3 + 3
‚ + CODE + 2 + 3
‚ + CODE + 2 + 2 + 3 + 3
‚ + CODE + 0
‚ + CODE + # + 1
‚ + CODE + 5 + X (X = a command
from the Audio Verification Set, 1=Talk,
2=VOX, 3=Listen)
‚ + CODE + 9 (Phone Command Mode)
‚ + 99 (AVM Mode)
11