Titan atrato Instruction Manual page 9

®
The flowmeter should be clipped into place with the terminal screws positioned at the lower
edge. Note that the rubber strip covering the terminals on the meter will not seal if water is
persistently present in this area. Ensure the meter is not pressure washed. The Atrato can
easily be dismounted by inserting a screwdriver under the mounting clip and gently unclipping
it to release the main body. The PG9 thread can be either connected to suitable flexible conduit
or may be fitted with the supplied cable gland.
Position flow meter to prevent gas lock in measurement tube
9
Titan Enterprises Ltd ©2021 Atrato_Instruction_Manual_0322