Furuno FM-8800D/8800S Installation Manual page 30

2. Fix the panel assembly to the Transceiver Unit with binding screws (use original binding
screws of the Transceiver Unit). Refer to the figure below.
3. Screw in hex bolts M8x16 and flat washers loosely at both sides of the Transceiver Unit.
4. Set the Transceiver Unit to the console, remove the grommets from the console and fix
the Transceiver Unit with hex bolts using the holes formerly occupied by the grommets.
Mounting of
the Transceiver Unit
Transceiver
Unit
Fix Mounting Plate
between washers.
5. Connect connector from the fuse to the power connector derived from the Transceiver
Unit.
3-2
Panel assembly
Insert console upside down.
Mounting
plate
Flat washer
Binding screw M4 2 places
(Use the original screws
of the Transceiver Unit.)
Washer M8
2 places
Hex bolt M8X16
(faster loosely)
2 places
Hex head screws
Close the hole with grommets
lastly.
Connecter
Connecter