Setting Up To Pour - PROALL G Series Operator's Manual

MX05001

Setting up to Pour

Upon arrival at the pour site, confirm the
specifications of the mix to be poured. Using the
following sequence, set up the mixer in
preparation for pouring.
NOTE: The following section refers to the
Operating Keypad on page 4-3. Please refer to this
page for further information on keypad buttons.
NOTE: The following section refers to the Mixer
Control System on page 4-1. Please refer to the
mixer computer manual for further information
on the computer.
1. Set the master electrical switch to ON. This
switch is in the Mixer Display Box (Figure 15).
2. Reset Emergency Stop Button, refer to page
4-1.
Figure 15. Mixer display box master electrical switch
3. Reset the job volume to zero by pressing the
reset button on the operating keypad –
button 5.
4. Select the mix required by the customer –
please refer to the Mixer Control System
Rev.
1
manual for information on setting the mix
values.
5. Set the aggregate bin discharge gate height
according to the desired mix design. SET AND
LOCK THE CONTROL GATE. Refer to the
Aggregate Control Gate section on page 6-1
for specific information concerning the
control gates.
6. Adjust the fibre feeder flow rates (refer to the
Fibre Feeder section on page 6-5.)
7. Pre-adjust conveyor and mix auger speeds.
Set speeds using the Operator Control (refer
to page 4-2.)
a. Adjust conveyor speed using the Error!
Reference source not found. and
Conveyor Speed button – button 3.
b. Adjust the mix auger speed using the
Error! Reference source not found. and
Auger Speed button – button 1.
8. Position sand material to point of discharge
into the mixing bowl
Push the Conveyor Feed button – button 80
on the Operating Keypad – to ON to start the
conveyor bringing the material to the
discharge point of the conveyor.
9. Extend the cement delivery tube.
10. Lower the Mix Auger using the Mix Auger
Paddle (refer to page 4-2). The transport lock
will automatically disengage when the boom
is lowered.
NOTE: DO NOT ALLOW the angle of the mix auger
to become too low as this will limit the ability of
the auger to mix thoroughly. An angle of no less
than 25 degrees should be used on the mixing
auger.
6-6
3 March 2022