Fibre Feeder - PROALL G Series Operator's Manual

Fibre Feeder

The ProAll fibre feeder is designed to supply a
controlled flow of fibre strands to the gunite mix.
NOTE: The fibre feeder discharge rate does not
change proportionally with changes in the
conveyor speed. Record the conveyor speed
setting when calibrating the fibre feeder and use
that conveyor speed whenever the fibre feeder is
used.
To adjust the fibre flow rate, increase or decrease
the air pressure with the air pressure control valve
(refer to Valve Location 7 on page 4-6.)
Load the fibre feeder by placing the fibre spool
into the fibre feeder cabinet. Fibre from the
center of the spool is fed into the tubing at the top
corner of the cabinet. The fibre is then passed
through the top hole of the fibre cutter and fed
through the rubber wheel and cutter as shown in
Figure 14.
WARNING
The fibre feeder cutter contains a cutting
wheel with very sharp knives. Care must
be taken when loading the cutter to
prevent being cut by the cutting wheel.
Rev.
1
Figure 13A & 13B. Fibre feeder.
Figure 14A & 14B. Fibre cutter.
6-5
MX05001
3 March 2022