Echo Sounder Settings - Furuno GP-7000F Installation Manual

3.3

Echo Sounder Settings

Setting transducer model, output power
The GP-7000F is preset to use a 600 W transducer (520-5PSD, 525-5PWD, 520-5MSD). For a 1
kW transducer, follow the procedure below. Note that the optional Distributor MB-1000 and cable
assy. 02S4089 are necessary in order to use a 1 kW transducer.
Output Power
600 W 520-5PSD, 525-5PWD, 520-5MSD
1 kW 50B-6, 50B-6G, 200B-5, 200B-5S, 50/200-IT
1. Use the [DISP] key to choose an echo sounder display.
2. Press the [MENU] key to show the menu bar.
3. Rotate the [ENTER] knob to choose SOUNDER from the menu bar and then push the
[ENTER] knob.
4. Rotate the [ENTER] knob to choose SOUNDER SETUP and then push the [ENTER] knob.
5. Rotate the [ENTER] knob to choose TRANSDUCER and then push the [ENTER] knob.
6. Rotate the [ENTER] knob to choose 1KW and then push the [ENTER] knob.
7. Press the [MENU] key to close all open windows and erase the menu bar.
Transducer
AUTO MODE PRESET
DISPLAY MODE
FREQUENCY
PICTURE ADVANCE
TEMPERATURE GRAPH
ZOOM MARKER
A-SCOPE
SOUNDER SETUP
SENSOR SETUP
ECHO SOUNDER SYSTEM SETUP menu
TRANSMISSION
TRANSMISSION POWER
TRANSDUCER
50 KHz TVG
200 KHz TVG
50 KHz ECHO OFFSET
200 KHz ECHO OFFSET
50 KHz BOTTOM LEVEL
200 KHz BOTTOM LEVEL
SMOOTHING
DEPTH INFORMATION
PLAYBACK SOUNDER IMAGE
ECHO SOUNDER SIMULATION Off
SOUNDER SETUP menu
600W
1KW
FISH
NORMAL
50 KHz
1/1
On
On
Off
On
High
600W
00
00
+000
+000
+000
+000
SM2
Large
Off
30