Table of Contents
Advertisement
SEQUENCER SECTION
1 Tremolo - switching the VCO rhythmically to LFO range (speed is
affected by RE-TRIG)
2 Fast RE-TRIG
3 RE-TRIG - combine with fast RE-TRIG to get 3rd speed ratchets
4 Arpeggio - fast four-octave jumps - combine with RE-TRIG to change
the speed
5 Pitch Envelope - combined with FX 6 makes less depth
6 Long Slide - just slow slew rate - affects everything pitch-related
7 Noise VCO modulation - combined with FX 6 makes deeper noise
8 Silencer - switches the VCO to LFO mode and mutes all envelope
triggers
To sequence-record the temporary FX, hold TRIG+PLAY and press GATES.
Release PLAY to loop the recorded interaction. The length of the loop
will be quantized to the nearest 8 steps; the maximum length is 64 steps.
TRIG+short press of PLAY will reset the temporary FX sequence.
You can also overdub and add more effects once the sequence is running
by holding TRIG+PLAY and pressing more GATES.
SEQUENCING OVERVIEW
There are 8 patterns with 8 steps each. The patterns can be chained to
create longer sequences.
Scales can also be chained and run independently from the pattern
chains.
Both are stored in memory when pressing SAVE.
On the right side of the unit, you can sequence-record the temporary
FX and chain the Play Modes. Their length is set independently from the
chained scales and patterns, so you can use different numbers to create
varying sequences.
Temporary FX loop and Play Mode chains are not stored in the memory
and are not impacted when loading new BANKS of patterns and scales.
You can load different BANKS of patterns and scales to run underneath
the Play Modes and temporary FX.
35
Advertisement
Table of Contents
