Table of Contents
Advertisement
CV is the voltage output of the sequencer. It only outputs the voltage
coming from the sequencer, and it is not affected by the oscillator controls:
PITCH FADER, PITCH MOD, TRANSPOSE, FINE-TUNE. The CV output
can also be set to output the voltage corresponding to the velocity of
the incoming note (MIDI+PATTERN). CV output range is -3V to +3V.
ENV Gate is a gate signal that is HIGH, while a step with an active
envelope gate is being played by the sequencer. ENV Gate is 0 to 5V.
SLIDE Gate is a gate signal that is HIGH, while a step with an active
SLIDE setting is being played by the sequencer. SLIDE Gate is 0 to 5V.
PLAY MODES
Play Modes are alternate paths of how the sequencer can browse through
the 8 steps to add variation and randomness. The sequence still stays 8
steps per pattern but re-maps those steps to a different order or skips
specific steps (indicated by the numbers in brackets). This means all
chains will still be advanced every 8 steps.
Hold PLAY and press a GATE to select a Play Mode (and release PLAY).
To chain multiple Play Modes, hold PLAY and press multiple GATEs.
Reset the chain by selecting just one Play Mode. The maximum number
of chained Play Modes is 16.
1 forward (1,2,3,4,5,6,7,8)
2 backward (8,7,6,5,4,3,2,1)
3 first 4 steps only (1,2,3,4,1,2,3,4)
4 last 4 steps only (5,6,7,8,5,6,7,8)
1 FORWARD
1–2–3–4–5–6–7–8
SEQUENCER SECTION
5 first 3 steps only (1,2,3,1,2,3,1,2)
6 last 3 steps only (6,7,8,6,7,8,6,7)
7 random first 4 steps only
8 random all 8 steps
2 BACKWARD
8–7–6–5–4–3–2–1
33
3 STEP 1–4
1–2–3–4–1–2–3–4
Advertisement
Table of Contents
