Removing An Extension Panel; Removing The Top Panel - Sun Microsystems Rack Service Manual

Removing an Extension Panel

1. Disconnect the grounding strap from the stud on the top inside of the panel.
2. Lift the panel up slightly and slide it toward the front of the rack.
To hold the panel in place, a tab attached to the panel slides into a bracket on the
rack side. There are two of these tabs and brackets, one at the top of the panel and
one at the bottom.

Removing the Top Panel

1. Disconnect the grounding strap from the stud on the top inside of the panel.
2. Disconnect the top panel power supply power cord from power strip.
3. Remove the logo panel from the top front of the rack, or if your Sun Rack has a
front door, open the door.
4. Loosen the four screws that secure the top panel to the rack.
5. Slide the top panel toward the front of the rack and lift it up to remove it from the
rack.
To replace the top panel, reverse the order of the removal procedure.
4 Sun Rack Service Manual • November 2002