Advertisement
TROUBLE SHOOTING: BEFORE YOU EMAIL FOR SERVICE PLEASE REVIEW THE TROUBLE SHOOTING TIPS FIRST.
Problem
Nothing happens when I press
the vacuum sealer.
Air is not removed from the bag
completely.
Liquids are bubbling during the
vacuum process.
16 INSTALLATION AND OPERATING INSTRUCTIONS
Possible Cause
1.
Power cord is not plugged in.
2. Power cord is damaged.
3. Power switch at rear of unit is not
turned on.
1. The bag has not been placed correctly
inside the chamber.
2. Debris covering sealing strip or gasket.
Sealing strip may be out of place.
3. Bag may have a hole.
4. Unit cover has not been closed
properly.
1.
The boiling point of liquids reduce
when atmospheric pressure is
reduced.
Solution
1. Make sure the power cord is correctly plugged into the electrical outlet, and
in the "on" position.
2. Check power cord and plug, and make sure they are not damaged in any way.
If damaged, do not use the vacuum sealer.
3. Turn rear power switch to on position.
1.
To seal properly, the bag clip should be situated inside the bag.
2. Check sealing strip and gasket for debris and wipe clean and smooth them
back into place.
3. To test, seal the bag with some air in it, submerge in water and apply
pressure. If there are bubbles present, it indicates a leak and a new bag
should be used.
4. Open cover and re-close the cover. You may need to press down on the
cover for a few seconds at the start of the vacuuming process.
1a. Always vacuum items when they are cold or slightly chilled.
1b. Minimise the eff ect by stopping the vacuum process when the pressure
gauge reaches -0.95 Bar, by activating the seal butt on.
Advertisement
