Technical Data; Preparations At The Workplace - Hilti NURON NCR 60 D-22 Manual

3.7 Selection of the connecting material
A table to assist with selecting the type of cable and cable terminal to be used can be found at the end of
these operating instructions.
4

Technical data

Rated voltage
Weight without battery
Max. crimping / pressing force
Crimping / pressing time
Max. permissible crimping ca-
pacity
Storage temperature
Ambient temperature for operation
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
WARNING
Risk of injury! If not aligned flush, lever and pivoting bar can fly out like projectiles.
▶ Before and during the crimping operation, make sure that lever and pivoting bar are correctly aligned.
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
Observe the safety instructions and warnings in this documentation and on the product.
8 English
NCR 60 DC-22
21.6 V
5.3 lb
(2.4 kg)
6,700 lb
(30 kN ... 60 kN)
≈ 5 s
Cu standard 500 MCM
strand
Cu fine strand 350 MCM
Al 350 MCM
−4 ℉ ... 158 ℉
(−20 ℃ ... 70 ℃)
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
NCR 60 D-22
21.6 V
5.3 lb
(2.4 kg)
... 13,500 lb 6,700 lb
f f
(30 kN ... 60 kN)
≈ 5 s
500 MCM
350 MCM
350 MCM
−4 ℉ ... 158 ℉
(−20 ℃ ... 70 ℃)
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
21.6 V
See the end of these
operating instructions
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
−4 ℉ ... 104 ℉
(−20 ℃ ... 40 ℃)
14 ℉ ... 113 ℉
(−10 ℃ ... 45 ℃)
2321725
*2321725*
... 13,500 lb
f f