Fuji Xerox B9136 Safety Notes page 36

Safety Notes
Always switch off and unplug the machine when it is
not used over weekends or long holidays. It may
cause deterioration of insulations and eventually
electric shock or a fire accident.
Once a month, switch off this product and check if
the power cord is plugged firmly into an electrical

outlet;
the plug is not excessively heated, rusted or bent;

 the plug and electrical outlet are free of dust; and
the power cord is not cracked or worn down.

Once you notice any unusual condition, switch off
and unplug this product first and contact your local
Fuji Xerox representative.
Machine Installation
Do not locate this product where people might step
on or trip over the power cord. Friction or excessive
pressure may generate heat and eventually cause
electric shock or a fire accident.
Never locate this product in the following places:
Near radiators or any other heat sources

Near volatile flammable materials such as curtains

 In the hot, humid, dusty or poorly ventilated
environment
 In the place receiving direct sunlight
Near cookers or humidifiers

Keep away the packing materials of machine from
small children. The thin film may cling to nose and
mouth and prevent breathing.
Locate this product on a level and sturdy surface that
can withstand a weight of 1281Kg (Main unit + High
Capacity Feeder + Interface Decurler Module D1 +
Inserter D1 + High Capacity Stacker A1 + Crease/Two-
sided Trimmer D2 + Finisher D6 with Booklet Maker +
Folder Unit CD2 + SquareFold Trimmer D1).
Otherwise, if tilted, the product may fall over and
cause injuries.
Locate this product in a well-ventilated area. Do not
obstruct ventilation openings of the product.
Keep the minimum clearance as follows for
ventilation and an access to the power plug. Unplug
the product if an abnormal condition is noted.
With Interface Decurler Module (optional), Finisher
D6 with Booklet (optional), Folder Unit CD2
(optional), and High Capacity Feeder (optional)
36
WARNING
CAUTION
4143
(Unit: mm)
With Interface Decurler Module (optional), Finisher D6 with
Booklet (optional), Folder Unit CD2 (optional), High Capacity
Stacker (optional), High Capacity Feeder C4-DS (optional) and
Crease/Two-sided Trimmer D2 (optional)
Do not incline the product at more than 10 degree
angle. Otherwise, it may fall over and cause injuries.
front
front
back
Always lock the wheels of this product after
installation. Otherwise, it may fall over or slide and
cause injuries.
To bundle wires and cables, always use the cable ties
and spiral tubes that Fuji Xerox supplies. Otherwise, it
may cause some defects.
To keep this product in a good performance and
condition, always
environment:
Temperature: 10 - 32°C

Humidity: 15 - 85%

When the product is left in a chilly room and the
room is rapidly warmed up by heater, dew
condensation may form inside the product and
cause a partial deletion on printing.
6447
(Unit: mm)
left
left
back
right
Others
use it in the
right
following